Common Sub-Zero refrigerator problems
Water under the crispers or on the floor: Water pooling under the crisper drawers usually means the defrost drain tube is frozen or clogged, so meltwater overflows inside the cabinet. Water on the floor can also come from the ice maker supply line or the water valve. We trace where it starts before replacing anything.
Frost on the back wall or a door that won't seal: Frost on the rear wall or around the door frame usually means warm, humid air is getting in: a torn or flattened gasket, a door that has sagged out of alignment, or a door closer that no longer pulls the door shut. Less often, a defrost component has stopped working.
Clicking, buzzing or constant starting and stopping: Some noise is normal: fans, water flowing, the ice maker dropping cubes. A new rattle, a squealing fan, or a compressor that clicks on and off every few minutes is not, and it's worth a look before the compressor overheats.
Ice maker or water dispenser stopped: If the freezer is cold and the ice maker still quits, the usual suspects are a clogged water filter, a water valve, low supply pressure, or a fill tube that froze. If the freezer has warmed up, we fix the temperature problem first, because the ice maker is often just a symptom.
Fresh-food side warm, freezer still cold: Because many Sub-Zero models cool each side separately, a warm refrigerator section with a normal freezer points to that side's own system: an evaporator fan that stopped, an evaporator packed with frost from a defrost fault, or a temperature sensor reporting the wrong value. We read temperatures and the control's history before ordering anything.
Both sections warm or the unit runs nonstop: A built-in that runs constantly and still can't hold temperature is often choking on a dirty condenser behind the top grille. Sub-Zero recommends cleaning it every six to twelve months, and many owners never have it done. If the coil is clean, we move on to the condenser fan, compressor start components and the control board.